-
PRS-DMM Programmable Self-Adjusting Resistance Standard- Patent pending
- Software leverages the accuracy of an 8.5 digit DMM, with the versatility of the PRS-300 Programmable Resistor to make the most revolutionary standard resistor ever manufactured
- Resistance Range: 0.1 Ω to 20 MΩ
- Resolution: 1 μΩ
- Accuracies better than 20 ppm; source resistance with the same accuracy that your 8.5 Digit DMM can measure.
- All you need to do is enter the target resistance. The software uses the DMM to measure the resistance being sourced by the PRS-300 and readjusts the source resistance as close as possible to the target resistance.
- Software automatically provides the measurement uncertainties of every measurement
-
OS-260 & OS-270 Resistance Decade Boxes / RTD Simulator- The revolutionary ohmSOURCE microprocessor controlled resistor is like nothing you have ever seen before!
- US Patent 6487456
- Two cost-effective models available
- Accuracy's as tight as 0.01%, with resolution as good as 0.01Ω
- Engineered as an ideal RTD calibrator
-
PRS Series Programmable Resistance Decade Box- IEEE, RS232 or Ethernet Programmable Decade Resistor
- Wide range and resolution: 1 mΩ to 100 MΩ
- Available at accuracies of : 0.01%, 0.02%, 0.05%, 0.1%, 0.5%, and 1%
- Special RTD and custom configurations
- Dual / Combo rackmount models ( examples: resistance & capacitance )
- Consider NEW PRS-300 Decade Resistor
-
VRS-100 Series High Resistance Standards- Set of nine, ten or eleven resistors - 1 kΩ, 10 kΩ, 100 kΩ,1 MΩ, 10 MΩ, 100 MΩ, 1 GΩ, 10 GΩ, 100 GΩ, 1 TΩ and 10 TΩ , open circuit (Depending on model)
- High Accuracy - up to 20 ppm
- Standard voltage: up to 5 kV (voltages of 10 kV are available)
- Excellent for calibration of Meggers
-
esi SR1010 Resistance Transfer Standard- Resistance Transfer Standards available in the following values 1 Ω, 10 Ω, 100 Ω, 1 kΩ, 10 kΩ, 100 kΩ
- Initial Accuracy... ± 20PPM of nominal value matched within 10PPM
- Transfer Accuracy... ± (1PPM + 0.1uΩ at parallel value) for 100:1
- Transfer Accuracy... ± (1PPM + 1uΩ at series parallel value) for 10:1
- Long Term Accuracy... ± 50PPM of nominal value
- Calibration Accuracy... ± 10PPM
-
HPRS-HIPOT-LOAD (Fluke 5320A-Load Hipot Replacement) Hipot Current Calibration Load Resistors- 8 Resistances from 10 kΩ to 5 MΩ standard
- Standard accuracy: ±10% at 23°C
- Power rating : up to 300 W at 100 kΩ
- Voltage rating: 1,400 to 5,500 V depending upon resistance value
- Continuous operation at rated power
- Kel-F washers on all terminals for low leakage current and high dielectric strength
- Custom values available for AR and QuadTech/Chroma hipot testers
Find out more about our different Resistance Decade Boxes